top of page
19655
19655-workbench-setup
19656-Contents
19655-use4
19656-Snap
19655-park2
19655-use1

DUAL OPERATOR MONITOR, UNIVERSAL POWER ADAPTER

Product Code: 19656

 

Dual Operator Workstation Continuous Monitor
Continuously monitors the path-to-ground integrity of two operators and one ESD worksurface

Wave Distortion Technology
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor

 

IMPROVED Operator Alarm
Alarms when the operator unintentionally disconnects from the monitor or the connection between the banana plug and monitor’s jack is intermittent

NEW Park Delay Timer
Indicates the 8 second delay to disconnect and park the operator wrist cord

NEW Visual Status Display
Displays the operators’ and worksurface status: illuminates red when

intermittent or failed connection occurs

NEW Mat Monitor Switch
Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface

NEW Audible Alarm Adjustment
Sets the audible alarm volume from loud to louder

NEW 19323 Power Relay Accessory
Controls power to workbenches, hand tools, and other electronic devices dependent on the Dual Operator Continuous Monitor’s status

Wave Distortion Technology
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor

Park Snap
Allows the operator to disconnect (and park) a wrist strap when leaving the workstation without creating a false alarm

Single-wire Impedance Design
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0

1.2 Volt Operator Test Voltage
Reduces the risk of electrical overstress (EOS) for the handling of sensitive components

<50 Millisecond Alarm Response Time
Identifies failures and intermittencies

Calibration Verification
Use the Desco 98221 Wave Distortion Monitor Verification Tester to check the test limits of Wave Distortion Monitors without removing them from their workstations

NIST Calibrated with Certificate Included
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. For more information on the calibration of Desco products, see Calibration.

100-240VAC Safety Certified Power Adapter with IEC C14 Style Inlet
Connects to a power cord with an IEC C13 outlet connector. See items 50545 and 50546.

Made in the United States of America
This item is made and stocked in Chino, CA

 

Click image to enlarge

bottom of page